Skip to content

K+M Tapered Reamer Large, 6mm-338 Calibre Calibre

SKU KMS-724338

Notify me when back in stock

K+M Case Mouth Tapered Reamer - An improvement to a long standing superb case mouth chamfering tool with a newly designed handle that provides improved depth stop fingers and a much needed set screw adjustment for precise cutter depth control. Still incorporated is the K+M Tapered Reamer same great cutter selection that uses a 4 degree taper per side that yields the finest case mouth chamfer for bullet seating for the competitive benchrest shooter and the demanding sportsman alike. The small tool uses a 6 flute cutter that chamfers cartridges from 6mm  up to .338 calibre. A smaller tool version uses a 3 flute cutter that chamfers cartridges from.17 calibre to 6mm calibre.

Renowned shooter Bob Pease wrote in an article, “For years I have refused to use any of the conventional deburring tools on the market. The taper is far too abrupt to prepare the case mouth for the bullet to enter smoothly. This is a very critical point in the assembly of accurate cartridges. I once saw a big gun shooter pinch the nose of a hollow point bullet completely flat with a pair of pliers. It went right into his excellent ten shot group. Next he took a pocket knife and put a scratch on the heel of a bullet so small it could hardly be seen. That bullet went out of the group by over ½ inch. Later I demonstrated this on numerous occasions to other new shooters. One cannot emphasis enough the need for complete protection of the bullet heel and base."